Coating Thickness
Our Series 500 coatings are applied utilizing a time controlled deposition process, which allows us to specify a wide range of thicknesses and hold tight tolerances. Depending on your application requirements, we routinely apply coatings as thin as 0.0002” per surface or as thick as 0.002” per surface, holding tolerancing within 0.0001” per surface. Our nominal thickness that we specify for the majority of our 500 Series coatings is 0.001”, which is held within +/- 0.0002” per side.
Surface Finish (RMS)
500 Series coatings are uniform and extremely conformal in nature. Unless you instruct Endura to grit blast prior to coating application, the majority of our 500 Series coatings will replicate your parts’ surface geometries and closely mirror their existing RMS surface values. If desired, 500 Series coatings are capable of being polished to a SPI A2 finish.
涂層厚度
我們的500系列涂層采用了時間控制沉積工藝，使我們能夠指定廣泛的厚度范圍，并保持嚴格的公差。根據您的應用要求，我們通常會使用厚度為每面0.0002英寸或每面0.002英寸厚的涂層，每個表面保持公差不超過0.0001。我們為我們的500系列涂層的大部分指定的公稱厚度是0.001“（在+/-中）0.0002”每邊。
表面光潔度
500系列涂層是均勻的，在本質上是非常一致的。除非你指導Endura為了在噴涂前進行噴砂處理，我們的500系列涂層將復制您的零件的表面幾何形狀，并密切反映其現有的均方根表面值。如果需要，500系列涂層可以拋光到SPIA2完成。 |
免責聲明： 以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，企業錄對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。